Acura MDX II facelift (2010-2013) (behind rear bumper) keyless buzzer/power tailgate buzzer wiring diagram
This page shows the only wiring diagram for the component.(behind rear bumper) keyless buzzer/power tailgate buzzer, which is found in the car Acura MDX II facelift (2010-2013). This component is only found in one wiring diagram on your vehicle, and you can see its details here. If necessary, you can also go to other diagrams for this system for more information..
(behind rear bumper) keyless buzzer/power tailgate buzzer wiring diagram (1 of 1)
+B BACKUP
+B BACKUP ATP-P
ATP-P CLU(+) VBU
B-CAN GTSW OHSW RACT
BLK WIRE
BLU WIRE
BRN WIRE
CLM(-) CLM(+) BUZ PPL
FUSE 21
FUSE 6 FUSE 11
GRN WIRE
GRY WIRE
HALF FULL NTL RS DR SW
HOT AT ALL TIMES
HOT AT ALL TIMES UNDER-DASH FUSE/RELAY BOX FUSE 7 (BEHIND LEFT KICK PANEL)
HOT IN ON OR START
KEYLESS B-CAN BUZZER
LT BLU WIRE
LT GRN WIRE
MICU
ORG/ WIRE
PNK SVCC WIRE
PNK WIRE
POWER TAILGATE CLOSER MOTOR (CENTER OF TAILGATE)
POWER TAILGATE CLUTCH
POWER TAILGATE CONTROL UNIT (CENTER OF TAILGATE)
POWER TAILGATE DRIVER UNIT (LEFT "D" PILLAR)
POWER TAILGATE INSIDE BEEPER
POWER TAILGATE MOTOR
POWER TAILGATE SENSOR
PPL
PPL PPL
PTG T/G SW FULL
PTG+
REAR FUSE/ RELAY BOX (LEFT SIDE OF CARGO AREA)
RED WIRE
SCOM
SG CLU-
TSER SENA SENB TSEL
WHT WIRE
YEL WIRE
Go to component -> Power tailgate circuit (1 of 2) -> (BEHIND REAR BUMPER) KEYLESS BUZZER/POWER TAILGATE BUZZER
