Acura MDX II (2006-2010) combination wiper switch wiring diagram
This page shows the only wiring diagram for the component.combination wiper switch, which is found in the car Acura MDX II (2006-2010). This component is only found in one wiring diagram on your vehicle, and you can see its details here. If necessary, you can also go to other diagrams for this system for more information..
combination wiper switch wiring diagram (1 of 1)
2 3 F-CAN (LO) F-CAN (HI)
2 4 F-CAN (LO) F-CAN (HI)
B-CAN
B-CAN MICU CHK
BLK WIRE
BRN WIRE
CHECK IN
COMBINATION SWITCH CONTROL UNIT
COMBINATION WIPER SWITCH
DLC (UNDER MIDDLE OF DASH)
DRIVER'S MPCS UNIT (IN DRIVER'S DOOR)
ENABLE IN
F-CAN HI
F-CAN LO
FUSE 7
GAUGE CONTROL MODULE
GRY WIRE
HOT AT ALL TIMES
LT BLU WIRE
LT GRN WIRE
MICU
MICU SERVICE CHECK CONNECTOR
PACKAGE) (UNDER RIGHT SIDE OF DASH)
PCM (RIGHT FRONT OF ENGINE COMPT)
POWER SUPPLY CIRCUIT/ CONTROLLER AREA NETWORK CONTROLLER
POWER WINDOW MASTER SWITCH
RED WIRE
STEERING ANGLE SENSOR (BEHIND STEERING COLUMN COVER)
UART
UART B-CAN
UNDER-DASH FUSE/RELAY BOX (BEHIND LEFT KICK PANEL)
UNDER-HOOD FUSE/RELAY BOX (RIGHT SIDE OF ENGINE COMPT) CONTROL BLOCK
VBU
WHT WIRE
YAW RATE-LATERAL ACCELERATION SENSOR (UNDER MIDDLE OF DASH)
Go to component -> Computer data lines circuit (1 of 3) -> COMBINATION WIPER SWITCH
